DSPIC33FJ128MC506A-E/PT

Operating Conditions

• 3.0V to 3.6V, -40ºC to +150ºC, DC to 20 MIPS

• 3.0V to 3.6V, -40ºC to +125ºC, DC to 40 MIPS

Core: 16-bit dsPIC33F CPU

• Code-efficient (C and Assembly) architecture

• Two 40-bit wide accumulators

• Single-cycle (MAC/MPY) with dual data fetch

• Single-cycle mixed-sign MUL plus hardware

divide

Clock Management

• ±2% internal oscillator

• Programmable PLLs and oscillator clock sources

• Fail-Safe Clock Monitor (FSCM)

• Independent Watchdog Timer (WDT)

• Fast wake-up and start-up

Power Management

• Low-power management modes (Sleep, Idle,

Doze)

• Integrated Power-on Reset and Brown-out Reset

• 1.35 mA/MHz dynamic current (typical)

• 55 μA IPD current (typical)

Motor Control PWM

• Up to four PWM generators with eight outputs

• Dead Time for rising and falling edges

• 12.5 ns PWM resolution

• PWM support for Motor Control: BLDC, PMSM, ACIM,

and SRM

• Programmable Fault inputs

• Flexible trigger for ADC conversions and configurations

Advanced Analog Features

• Two ADC modules:

- Configurable as 10-bit, 1.1 Msps with four

S&H or 12-bit, 500 ksps with one S&H

- 18 analog inputs on 64-pin devices and up to

32 analog inputs on 100-pin devices

• Flexible and independent ADC trigger sources

Timers/Output Compare/Input Capture  

• Up to nine 16-bit timers/counters. Can pair up to

make four 32-bit timers.

• Eight Output Compare modules configurable as

timers/counters

• Eight Input Capture modules

Communication Interfaces

• Two UART modules (10 Mbps)

- With support for LIN 2.0 protocols and IrDA®

• Two 4-wire SPI modules (15 Mbps)

• Up to two I2C™ modules (up to 1 Mbaud) with

SMBus support

• Up to two Enhanced CAN (ECAN) modules

(1 Mbaud) with 2.0B support

• Quadrature Encoder Interface (QEI) module

• Data Converter Interface (DCI) module with I2S codec support

Input/Output

• Sink/Source up to 10 mA (pin specific) for standard VOH/VOL, up to 16 mA (pin specific) for nonstandard VOH1

• 5V-tolerant pins

• Selectable open drain, pull-ups, and pull-downs

• Up to 5 mA overvoltage clamp current

• External interrupts on all I/O pins

Qualification and Class B Support

• AEC-Q100 REVG (Grade 1 -40ºC to +125ºC)

• AEC-Q100 REVG (Grade 0 -40ºC to +150ºC)

• Class B Safety Library, IEC 60730

Debugger Development Support

• In-circuit and in-application programming

• Two program and two complex data breakpoints

• IEEE 1149.2-compatible (JTAG) boundary scan

• Trace and run-time watch